I have this LED outdoor lighting have risen to a small additional lighting for my bike built shelter. I'm thrilled so far! If one takes the time and the LED aligns slightly better light in the desired direction. In my set is a technique that is installed nowhere described. It is neither on the box, nor on the website and not to the product video of Pearl. It's like the two LEDs are very bright and are controlled by motion detectors. A third LED is a little less bright lights and long term. But only when it is dark enough. It is a kind, so to speak dar. orientation light and also serves to battery maintenance.
A faulty connection can be excluded because it was certainly done with the idiots waterproof connectors so it's not only this way or that fits!
But pictures say more than words ...
first two pictures show the instalation on the bike-shed roof.
picture two shows the front view, left and center is one of the PIR (right)-connected LEDs and the LED is permanently lit inside in the corner and therefore the interior lights from enough.
The other pictures I had done immediately after unpacking.
is clearly visible that the single LED is always on when it is dark enough. The advantage of what the glowing LED on time is added, and the batteries are well trained and loaded and unloaded by the batteries stay alive longer.
too well I think that you would like the batteries if you can also swap. The water density Flap is easily accessible and therefore can be after a good 4 or 5 years replace the battery once, because often no longer hold in the high "stress" winter.
Advantages: Fast and for everyone
not craftsmen logical and easy installation possible.
parts like spikes and feet, Gelenlenke have a good quality.
All connections are rubberized and water resistant.
cables are long in any case enough for my purposes. A radius of 6 meters is feasible.
cable length about 4.50 the longest. LEDs are super bright
few hours of sunlight (about 4 hours) is enough.
The PIR is up to 8 meters in a position movement be identified.
The light sensor turns the system really only when it is dark, not too early.
disadvantages.
The LEDs are not good enough just to the reflector.
patchy illumination a lens would have been better than clear glass. No switch off
the single life LED.
Techniche Datails:
are Included are 2 different types of lamps. The two lights that are activated by the motion detector, have a current consumption of 0.25 watts. The LED has a brightness-dependent power consumption of 0.1 watts.
Sounds little but enough for my Purpose completely.
0 comments:
Post a Comment